Samsung HLP4663W Instruction Manual

Also see for HL-P5063W: Manual Quick guide Instruction manual Instruction manual Instruction manual

Contents

11Your New Wide TV10Front Panel LED IndicatorsThe three lights on the front panel indicate the status of your TV.: Light is On: Light is Blinking: Light is Off• It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.• The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.Timer Lamp Temp IndicationAuto Timer ON/OFF has been set.Standby state.The picture will automatically appear in about 15 seconds.Auto Timer ON/OFF has been set and the set will automatically be turned on inabout 25 seconds.A cooling fan inside the set is not operating normally.Lamp cover on rear of the set is not properly shut.Check if the ventilation hole on the rear of the set is blocked, because if theinner temperature is too high, the power will shut off.Lamp may be defective. Please contact a certified technician.Rear Panel JacksUse the rear panel jacks to connect components such as a VCR. You can connect different componentssuch as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks andthree set of component video input jacks on the rear panel of your TV. For more information, please see“Connections”.Œ ANTENNA terminalsTwo independent cables or antennas can be connected to these terminals.Use “ANT 1 IN” and “ANT 2 IN” terminals to receive a signal fromVHF/UHF antennas or your cable system. Use the “ANT 1 OUT” terminal tosend the signal being received by the “ANT 1 IN” terminal out to anothercomponent (such as a Cable Se-Top Box). The PIP channel can be receivedonly when a signal source is connected to “ANT 1 IN”.´ S-VIDEO INPUT jacksConnects an S-Video signal from an S-VHS VCR or DVD player.ˇ VIDEO/AUDIO INPUT jacks (VCR1, VCR2)Connect video/audio signals from external sources, such as a VCR or DVDplayers.¨ VIDEO/AUDIO OUTPUT jacksSends a video signal from the TV to an external source, such as a VCR.Note: It is available only in RF, Video and S-Video modes.ˆ Component1, 2 jacks (Y, PB, PR, L, R)Use these jacks to connect the component video/audio signals from a DVDplayer or a set top box when using the component video input jacks.Ø PC AUDIO INPUT jacksConnect these to the audio output jacks on your PC.∏ PC VIDEO INPUT jackConnect these to the video output jack on your PC .” DVI (Digital Video Interface) AUDIO INPUT jacksConnect to the digital audio output jacks for device with DVI output.’ DVI (Digital Video Interface) VIDEO INPUT jackConnect to the digital video output jack for device with DVI output.˝ HDMI (High Definition Multimedia Interface)VIDEO/AUDIO INPUT jackConnect to the HDMI jack for device with HDMI output.Ô SERVICEThis jack is for repair and software upgrades.Remote Control SensorAim the remote control towards this spot on the TV.POWERPress to turn the TV on and off.