Samsung HT-D7000 User Manual

Contents

English 2302 ConnectionsWireless NetworkYou can connect to the network with a Wireless IP sharer.A wireless AP/IP router is required to make a wireless network connection. Connect the wirelessLAN adapter to the Wireless LAN Adapter on the rear panel of the product.Set the network options. (See page 33)NOTEThis product is compatible with only Samsung's Wireless LAN Adapter. (not supplied) (Model name:WIS09ABGN).- The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer forpurchasing.You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stableoperation of the wireless network.)Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance,distance, obstacles, interference by other radio devices, etc).Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.When applying the security key for the AP (wireless IP sharer), only the following is supported.Authentication Mode : WEP, WPAPSK, WPA2PSKEncryption Type : WEP, AESFor the AllShare function, a PC must be connected in the network as shown in the figure.1.2.✎ 1)2)Wireless IP sharerWireless LAN Adapter(not supplied)BroadbandserviceNetworking with PC forAllShare function(See page 63)PCConnecting the FM AntennaConnect the FM antenna supplied to the FMANTENNA Jack.Slowly move the antenna wire around until youfind a location where reception is good, thenfasten it to a wall or other rigid surface.NOTEThis product does not receive AM broadcasts.1.2.✎FM Antenna (supplied)HT-D7000_ELS_1227.indd 23HT-D7000_ELS_1227.indd 23 2011-12-27 11:03:592011-12-27 11:03:59