Samsung HT-J4200 User Manual

Also see for HT-J4200: User manual

Contents

12 - EnglishSettingsThe Initial Settings Procedure• The Home menu will not appear if you do notconfigure the initial settings.• The OSD (On Screen Display) may change inthis product after you upgrade the softwareversion.• The access steps may differ depending on themenu you selected.1. Turn on your TV after connecting the product,and then turn on the product. When you turnon the product for the first time, the productautomatically displays the Setup Languagescreen.2. Press the ▲▼ buttons to select the desiredlanguage, and then press the v button.3. Press the v button to start function setup.SetupTV Aspect and Network will be set.Each setting may be changed later under "Settings"a Previous " SelectStart4. The TV Aspect Ratio screen appears. Pressthe ▲▼ buttons to select a TV aspect ratio, andthen press the v button.You have four choices:16:9 Original - For widescreen TVs. Displayswidescreen pictures in their original 16:9 formatand 4:3 pictures (the old, standard format) in 4:3pillar box format with black bars on the left andright.16:9 Full - For widescreen TVs. Displayswidescreen pictures in their original 16:9 formatand expands 4:3 pictures to fill the 16:9 screen.4:3 Letter Box - For older, standard screen,analogue TVs. Displays 4:3 pictures in full screenand 16:9 pictures in letter box format that retainsthe 16:9 aspect ratio but puts black bars aboveand below the picture.4:3 Pan-Scan - For older, standard screen,analogue TVs. Displays 4:3 pictures in full screenand 16:9 pictures in Pan-Scan format that fillsthe screen, but cuts off the left and right sides ofthe picture and enlarges the middle vertically.5. The Network - Wired screen appears.- If you have a network with dynamic IPaddresses - and most people do - selectAuto, press the v button, and then go toStep 6.- If you have a network with static IP addresses,we suggest you select Skip by pressing theBLUE (D) button. (See page 17)- If you have no network, select Skip bypressing the BLUE (D) button. The InitialSettings Complete screen appears, and thenthe Home screen appears.✎ If you skip network setup here or the setup doesnot work correctly, you can set up the product'snetwork connection later. (See page 17)Setup | Network - WiredAuto ManualChoose the method to configure Internet Protocol (IP). Please make sure that Ethernetcable is connected.Auto : Configure IP automatically.a Previous d Skip < Move " Select6. The product verifies the network connectionand then connects to the network. When it isdone, press the v button. The "Initial settingscompleted." screen appears, and then theHome screen appears.✓✓✓✓Setup | Network - WiredMAC Address (d0:66:7b:dc:28:fc)IP Address, Subnet Mask, Gateway, DNS ServerGateway PingInternet Service Test" SelectOKYour network is operating properly. If you still have a network problem, contact yournetwork service provider.