Samsung IPX-G5X0 series Installation Manual

Contents

SAMSUNG IPX-G5X0 Installation Manual v1.0 Mar 201616IPX-G500B Basic ConfigurationOnce connected via serial to the IPX-G500B, you can enter your network information into the gateway.There are options to setup the gateway in a LAN or NAT configuration (see examples in the followingpages). Use the following steps to enter network information. Select ‘1. Setup Basic Configuration’. According to the prompt, select the network mode. LAN or NAT If you select NAT: Enter the WAN IP Address, Gateway and Subnet Mask of the IPX-G500B. Enter the LAN IP Address, Gateway and Subnet Mask of the IPX-G500B. If you select LAN: Enter the LAN IP Address, Gateway and Subnet Mask of the IPX-G500B. Enter the SCM Composite IP Address. Enter the Gateway Name. This must match the Gateway Name in the SCM Configuration. After all information is entered it will ask if you want to reset the system to apply the changes. To reboot the system enter ‘yes’, otherwise enter ‘no’###### Please enter network mode of this GW ######1. Enter Networkmode [0:LAN / 1:NAT] (Enter Key : NAT) :###### Please enter [WAN IP/Gateway/Subnet Mask] of this GW ######1. Enter WAN IP Address (Enter Key : 10.251.0.10 ) :2. Enter Gateway Address (Enter Key : 10.251.0.1 ) :3. Enter WAN IP Subnet Mask (Enter Key : 255.255.255.0 ) :###### Please enter [LAN IP/Subnet Mask] of this GW ######1. Enter LAN IP Address (Enter Key : 192.168.0.1 ) :2. Enter LAN IP Subnet Mask (Enter Key : 255.255.255.0 ) :###### Please enter the IP Address of SCME ######1. Enter SCME IP Address (Enter Key : 10.251.0.100 ) :###### Please enter the name of this GW (Max 30char) ######1. Enter Name of this GW (Enter Key : G500_default ) : G500Site1End of Configuration. To apply it, please restart the system.Do you want to restart? (yes/no) :