Samsung IPX-G5X0 series Installation Manual

Contents

SAMSUNG IPX-G5X0 Installation Manual v1.0 Mar 201619IPX-G520S/G540S (ECU) Basic ConfigurationUse the following steps to connect to the serial console: Connect a serial cable to the console port of the system. Run a serial terminal program (I.E., PuTTY, etc.) on your PC and set the baud rate to 38,400. The default login ID is: admin / The default Password is: samsung*# Enter ‘cli’ to set up the basic gateway configuration. Select ‘1. Setup basic configuration’. Following the prompts enter the IP Address of the ECU, Gateway IP Address, and Subnet Mask. Enter the LAN IP Address of the main IPX-G500B, which this expansion cabinet will be connected to.Note: The IPX-G520S/G540S LAN port should be connected to the same LAN network as the IPX0-G500. Assign the sequence number from 1 to 6 for this expansion cabinet. It should be unique for eachgateway. After all information is entered it will ask if you want to reset the system to apply the changes. To reboot the system enter ‘yes’, otherwise enter ‘no’###### Please enter [IP/Gateway/Subnet Mask] of this ECU ######1. Enter ECU IP Address (Enter Key : 10.251.0.11 ) :2. Enter Gateway Address (Enter Key : 10.251.0.1 ) :3. Enter Subnet Mask (Enter Key : 255.255.255.0 ) :###### Please enter the IP Address of CMU ######1. Enter CMU IP Address (Enter Key : 10.251.0.10 ) :1. Enter this ECU number (Enter Key : 1) :End of Configuration. To apply it, please restart the system.Do you want to restart? (yes/no) :