《73》PictBridge : Reset■ Initialises user-changed configurations.1. Use the Up / Down buttons to select the [Reset]menu tab. And then press the Right button.2. Use the Up / Down buttons to select the desiredsub menu value, and then press the OK button.If [No] is selected : Settings will not be reset.If [Yes] is selected : All print and image settingswill be reset.※ Default print setting varies depending on the printer manufacturer.For your printer’s default setting, refer to the user’s guide that came with yourprinter.LayoutPICTBRIDGEQualityYesNoType Date File Reset Move PrintImportant notesBe sure to observe the following precautions!■ This unit contains precision electronic components. Do not use or store this unitin the following locations.- Areas exposed to severe changes in temperature and humidity.- Areas exposed to dust and dirt.- Areas exposed to direct sunlight or the inside of a vehicle in hot weather.- Environments where there is high magnetism or excessive vibration.- Areas with high explosives or highly flammable materials.■ Do not leave this camera in places subject to dust, chemicals (like naphthaleneand mothball), high temperature and high humidity.Keep this camera with silica gel in a hermetically sealed box when not planningto use the camera for a long period of time■ Sand can be particularly troublesome to cameras.- Do not let sand get inside the camera when using it on beaches, coastaldunes, or other areas where there is lots of sand.- Doing so may result in failure or may permanently render the camera unusable.■ Handling the camera- Never drop the camera or subject it to severe shocks or vibrations.- Protect the large size LCD monitor from an impact. When this camera is notused, keep it in the camera case.- Avoid obstructing the lens or the flash when you capture an image.- This camera is not waterproof.To avoid dangerous electrical shocks, never hold or operate the camera withwet hands.- If you use this camera in wet places, such as beach or pool, do not let water orsand get inside the camera. Doing so may result in failure or may permanentlydamage the unit.