English - 10Connecting a VCRThese instructions assume that you have already connected your TV to an antenna or a cable TV system (according to theinstructions on pages 6~7). Skip step 1 if you have not yet connected to an antenna or a cable system.1. Unplug the cable or antennafrom the back of the TV.2. Connect the cable or antenna tothe ANT IN terminal on the backof the VCR.3. Connect an RF Cable betweenthe ANT OUT terminal on theVCR and the ANT IN terminalon the TV.4. Connect a Video Cablebetween the VIDEO OUT jackon the VCR and the AV IN[VIDEO] jack on the TV.5. Connect Audio Cablesbetween the AUDIO OUTjacks on the VCR and theAV IN [R-AUDIO-L] jacks onthe TV.If you have a “mono”(non-stereo) VCR, use aY-connector (not supplied)to hook up to the right andleft audio input jacks of theTV. If your VCRis stereo,you must connect twocables.Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.Each VCR has a different back panel configuration.When connecting a VCR, match the color of the connection terminal to the cable.Your Samsung TV can be connected to an S-Video jack on a VCR.(This connection delivers a better picture when compared to the regular Video connection above.)1. To begin, follow steps 1–3in the previous section toconnect the antenna orcable to your VCR and yourTV.2. Connect an S-Video Cablebetween the S-VIDEO OUTjack on the VCR and theAV IN [S-VIDEO] jack onthe TV.3. Connect Audio Cablesbetween the AUDIO OUTjacks on the VCR and theAV IN [R-AUDIO-L] jacks onthe TV.An S-Video cable may be included with a VCR. (If not, check your local electronics store.)Each VCR has a different back panel configuration.When connecting a VCR, match the color of the connection terminal to the cable.Video ConnectionS-Video ConnectionANT INVCR Rear PanelRF Cable (Not supplied)1Audio Cable (Not supplied)TV Rear PanelS-Video Cable (Not supplied)2VCR Rear PanelVideo Cable (Not supplied)4Audio Cable (Not supplied)RF Cable (Not supplied)TV Rear Panel
