24 EnglishAdvanced Featuresnetwork setup (Auto)Use the Automatic network setup when connecting yourTV to a network that supports DHCP. To set up your TV’scable network connection automatically, follow these steps:how to set up automatically1. Connect your TV to your LAN as described in theprevious section.2. Turn on your TV, press the MEnU button on yourremote, use the ▲or▼ button to select setup, and thenpress the EnTERE button.3. Use the ▲or▼ button to select Network in the setupmenu, and then press the EnTERE button. TheNetwork screen appears.4. On the network screen, select network Type.5. Set network Type to Wired.6. Select network setup. The network setup screenappears.7. Set Internet Protocol setup to Auto.8. Auto acquires and enters the needed Internet valuesautomatically.9. Wait two minutes, and then press the RETURn buttonon your remote.10. If the network Function has not acquired the networkconnection values, go to the directions for Manual.network setup (Manual)Use the Manual network setup when connecting your TV toa network that requires a Static IP address.getting the network Connection ValuesTo get the Network connection values on most Windowscomputers, follow these steps:1. Right click the Network icon on the bottom right of thescreen.2. In the pop-up menu that appears, click Status.3. On the dialog that appears, click the Support tab.4. On the Support Tab, click the Details button. TheNetwork connection values are displayed.how to set up manuallyTo set up your TV’s cable network connection manually,follow these steps:1. Follow Steps 1 through 6 in the “How to set upautomatically” procedure.2. Set Internet Protocol setup to Manual.3. Press the ▼ button on your remote to go to the firstentry field.4. Enter the IP Address, subnet Mask, gateway, andDns server values. Use the number buttons on yourremote to enter numbers and the arrow buttons to movefrom one entry field to another.5. When done, press the RETURn button on your remote.6. Select network Test to check the Internet connectivity.NetworkNetwork Type : Wired ►Network SetupNetwork testU Move E Enter R ReturnNetwork SetupInternet Protocol Setup : Auto ►IP Address :Subnet Mask :Gateway :DNS : AutoDNS Server :U Move E Enter R ReturnBN68-02604A_Eng.indb 24 2010-02-10 �� 8:19:20