Network Settings and lnfoLinkTo access Samsung's Infolink network feature, you must make one of the connections on the following pages.Network Connection - CableLAN Connection for a DHCP EnvironmentThe procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since anIP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enterthem manually.The Modem Porton the WallExternal Modem(ADSLNDSL/Cable TV)TV RearPanel 1. Connect the[LAN] port onthe rear panel ofthe TV and theexternal modemwith a LAN Cable.2. Connect the LANport on the walland the externalmodem with aLAN Cable.You can connect the LAN via a Sharer (Router).IP Sharer TV Rear PanelExternal Mod_The Modem Port (ADSL/VDSL/on the Wall Cable TV)LAN CableYou can connectthe LAN port andthe TV directly depending on yournetworkstatus.TV Rear PanelThe LAN PortontheWallLAN Cable>- The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.>- If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10seconds and then try again.>- For the connections between the external modem and the Sharer (Router), refer to the owner's manual of thecorresponding product.>- You can connect the TV to the LAN directly without connecting it through a Sharer (Router)>- You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use anautomatic-connection-type ADSL modem.
