E-5ENGLISHC OMPLETING THE INSTALLATIONPreparation for installationWhen deciding on the location of the air conditioner with the owner,the following restrictions must be taken into account.Do NOT install the air conditioner in a location where it will come intocontact with the following elements: Combustible gases Saline air Machine oil Sulphide gas Special environmental conditionsIf you must install the unit in such conditions, first consult your dealer.GeneralAvoid installing the air conditioner: In areas where it is exposed to direct sunlight. Close to heat sources. In damp areas or locations where it could come into contact with water(for example rooms used for laundry) In areas where curtains and furniture could affect the supply and discharge of air. Without leaving the required minimum space around the unit (as shown in thedrawing). In scarcely ventilated areas. On surfaces that are unable to support the weight of the unit without deforming,breaking or causing vibrations during the use of the air conditioner. In a position that does not enable the condensate drainage pipe to be correctlyinstalled (at the end of the installation. It is always essential to check the efficiencyof the drainage system.) You have just purchased a Free Joint Multi air conditioner and it has been installed byyour installa-tion specialist. This device must be installed according to the national electrical rules. Max input power & current is measured according to IEC standard and input power ¤t ismeasured according to ISO standard.CAUTIONFJM_IM_DB98-31792_E_6.10.10.indd 5 2010-6-10 9:53:14