E-2Safety PrecautionsThe following safety precautions must be taken when using your air conditioner. The unit should not be installed by the user. Ask the dealer or authorizedcompany to install the units except room air conditioners for the U.S.A andCanada area. If the unit is installed improperly, water leakage, electric shock or fire mayresult. The air conditioner must be installed in accordance with national wiringregulations and safety regulations wherever applicable. Mount with the lowest moving parts at least 2.5 m above the floor or gradelevel. (If applicable) The manufacturer does not assume responsibility for accidents or injurycaused by an incorrectly installed air conditioner. If you are unsure aboutinstallation, contact an installation specialist. When installing the built-in type air conditioner, keep all electrical cablessuch as the power cable and the connection cord in pipe, ducts, cablechannels e.t.c to protect them against liquids, outside impacts and so on.WARNINGINSTALLING THE UNIT If the power cord of this air conditioner is damaged, it must be replaced bythe manufacturer, its service agent or similarly qualified persons in order toavoid a hazard. The unit must be plugged into an independent circuit if applicable orconnect the power cable to the auxiliary circuit breaker. An all poledisconnection from the power supply must be incorporated in the fixedwiring with a contact opening of >3mm. Do not use an extension cord with this product. If the unit is equipped with a power supply cord and a plug, the plug mustbe accessible after installation. This appliance must be installed accordance with the national wiringregulations.POWER SUPPLY LINE,FUSE OR CIRCUITBREAKERRisk of electric shock. • Can cause injury or death. • Disconnect allremote electric power supplies before servicing, installing or cleaning.• This must be done by the manufacturer or its service agent or a similarqualified person in order to avoid a hazard.