ixCanadian Radio Interference RegulationsThis digital apparatus does not exceed the Class B limits for radio noise emissionsfrom digital apparatus as set out in the interference-causing equipment standardentitled “Digital Apparatus”, ICES-003 of the Industry and Science Canada.Cet appareil numérique respecte les limites de bruits radioélectriques applicables auxappareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur:“Appareils Numériques”, ICES-003 édictée par l’Industrie et Sciences Canada.United States of AmericaFederal Communications Commission (FCC)Intentional emitter per FCC Part 15Low power, Radio LAN type devices (radio frequency (RF) wireless communicationdevices), operating in the 2.4 GHz Band, may be present (embedded) in your printersystem. This section is only applicable if these devices are present. Refer to thesystem label to verify the presence of wireless devices.Wireless devices that may be in your system are only qualified for use in the UnitedStates of America if an FCC ID number is on the system label.The FCC has set a general guideline of 20 cm (8 inches) separation between thedevice and the body, for use of a wireless device near the body (this does not includeextremities). This device should be used more than 20 cm (8 inches) from the bodywhen wireless devices are on. The power output of the wireless device (or devices),which may be embedded in your printer, is well below the RF exposure limits as setby the FCC.This transmitter must not be collocated or operation in conjunction with any otherantenna or transmitter.Operation of this device is subject to the following two conditions:(1) This device maynot cause harmful interference, and(2) this device must accept any interferencereceived, including interference that may cause undesired operation of the device.Wireless devices are not user serviceable. Do not modify them in anyway. Modification to a wireless device will void the authorization to useit. Contact manufacturer for service.FCC Statement for Wireless LAN use:“While installing and operating this transmitter and antenna combinationthe radio frequency exposure limit of 1mW/cm2 may be exceeded atdistances close to the antenna installed. Therefore, the user mustmaintain a minimum distance of 20cm from the antenna at all times.This device can not be colocated with another transmitter andtransmitting antenna.”
