Problem Solving84l Distribute the toner in toner cartridge.(See page 69)l Adjust the ‘Density’ menu item setting.(See page 52)l Clean the inside of the printer.(See page 72.)l Print a few more pages to see if the problemwill correct itself.l Clean the inside of the printer.(See page 72.)l Check the paper type and quality.l Check the paper type and quality.l Check the printers environment.l Install a new toner cartridge.l Check the printer cable connections.l Close the SM(Smart Monitor) program.l Check the printer cable connections.l You cannot monitor the status of the printer whichis connected by network. Close theSM(Smart Monitor) program.l Much printing may accumulate toners on thepressure roller of fuser assy. The accumulated tonermay be melted and transferred on the back side ofpaper.l Select ‘FUSER CLEAN’ in the JOB MENU.l ‘FUSER CLEAN’ selection rotate the motor about 10seconds and print one page duplex printing ofspecified pattern for fuser clean and stop.The vertical lines areprinted onthe page.Print is too light.There are tonerspeckles.The printerdrops lettersThe printer dropsletters in case ofprinting from Dosmode in Windows 95“Check parallelCable/Smart Monitorcan not monitornetwork printing”appears in SmartMonitor program.Dirty spots on theback side of paper offuser assycontamination.Poor Print QualityProblem Solution
