E-17ENGLISHSetting the Auto Stop FunctionThe wired remote controller can be set to turn off the indoorunit(s) after a set period of time has passed since any button onthe remote controller was last pressed. This function is used toturn off the indoor unit in case the user forgets to turn off theindoor unit.1 Press the button for 3 seconds to enter the setupmode.Result: The wired remote controller will enter thesetup mode and the menu will display . Press the button to enter the Auto Stopsetup mode.2 Press the buttons to set the auto stop time.Result: Time is adjusted by 1 hour when thebuttons are pressed. The default time setting is 0. The auto stoptime can be set between 0 and 12 hours. If you select 0, auto stop function will becanceled.3 Press the button to complete the auto stop function.Result: Auto stop function is set.Note To cancel the auto stop function, press thebutton.4 Press the button.Result: Menu selection display will end. will be displayed.Note The time-counting of Auto Stop function is clearafter pressing the , , , , ,, buttons. Auto Stop function doesn’t work under thecentralized control.MWR-WH00_IB_E_31218-1.indd 17 2009-12-14 ソタネト 3:31:59