Samsung NX300 Service Manual

Also see for NX300: User manual User manual User manual Manual Del Usuario

Contents

Copyrightⓒ since 1995 Samsung Electronics. All rights reserved. 8-3Adjustment3. LENS CONTROL(1) OIS ADJUSTMENT- When you adjust the OIS function which have a OIS lens, you can adjust it.- How to adjustAttach the Lens and follow the below step.From the TEST MODE, select LENS CONTROL → select OIS ADJUSTMENT → Press the OK button.* Caution : Do not move the camera during the adjustment process.(2) ZOOM WIDE SET and ZOOM TELE SET- When you adjust the position of zoom position, you can use it.(It is required to adjust the process when replacing PCB inside lens or installing the Mount.)- How to adjustAttach the Lens and follow the below step.From the TEST MODE, select LENS CONTROL → select ZOOM WIDE SET→ set the zoom to the Wide. → Press the OK button.(Repeat the above steps for ZOOM TELE SET.)* Caution : Do not move the camera during the adjustment process.8-3 CIS TILT Adjustment■ Proceed CMOS Tilt adjustment after replacing CMOS ASSY.1. Set the CIS Tilt adjustment tools. (Kyoritsu (RSM-5000))2. Once you press the Start button, Tilt adjustment will complete automatically.3. After adjustment completion, Apply glue on 3 screws to fix the screw position as illustrated in Fig. 8-2.Adjust specification for Mount side and FLANGE BACK side : 25.55mm(-35mm/+15mm)Adjust specification for CMOS sensor TILT side from center: -30um/+30um* Caution : The above three screws for NX10/5/11, NX100, NX200 and NX300 may vary in model.Fig. 8-2The screw for CMOS Tilt adjustment.