Samsung OM46D-W User Manual

Also see for OM46D-K: Quick setup guide User manual

Contents

Set the network connection to use Internet services such as perform software upgrades.Automatic Network Settings (Wired)Connect to the network using a LAN cable.Make sure a LAN cable is connected first.How to set up automatically1 Set Network Type to Wired from the Network Settings page.2 Press the Connect button to start Network Settings.- The Connect button is only enabled when the LAN cable is properly connected.3 The network test screen appears and verifies the network connection.When the connection has been verified, the “Wired network and Internet connectioncompleted.” message appears.― If the connection process fails, check the LAN port connection.― If the automatic process cannot find the network connection values or if you want to set theconnection manually, go to the next section, network setup.Manual Network Settings (Wired)Offices may use static IP addresses.If this is the case, ask the network administrator for the IP address, subnet mask, gateway and DNS serveraddress. Enter these values manually.Getting the Network Connection ValuesTo view the Network connection values on most Windows computers, follow these steps.1 Right click the Network icon on the bottom right of the screen.2 In the pop-up menu that appears, click Status.3 On the dialog that appears, click the Support tab.4 On the Support Tab, click the Details button. The Network connection values are displayed.How to set up manually1 Set Network Type to Wired from the Network Settings page.2 Press the Connect button to start Network Settings.- The Connect button is only enabled when the LAN cable is properly connected.3 The network test screen appears and the verification process starts. Press Stop. The verificationprocess stops.4 Select IP Settings on network connection screen. The IP Settings screen appears.5 Select the field at the top, press E, and then set IP Settings to Enter manually. Repeat the entryprocess for each field in the IP Address.― Setting IP Settings to Enter manually automatically changes DNS Setting to Enter manually.6 When done, select OK at the bottom of the page, and then press E. The network test screenappears and the verification process starts.7 When the connection has been verified, the “Wired network and Internet connectioncompleted.” message appears.