Samsung OfficeServ 7100 Installation Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

Contents

OfficeServ 7100 Installation Manual© SAMSUNG Electronics Co., Ltd. 8-38.2 Starting the SystemThe procedure for starting the OfficeServ 7100 system is as follows:1) Check if the boards and cables are properly mounted and connected to the OfficeServ7100 cabinet.2) Turn on the power of the OfficeServ 7100 basic cabinet, and turn on the power of theexpansion cabinet.3) Check the LEDs for the MP10/11 boards mounted on the OfficeServ 7100 cabinet.y The RUN LED of the MP10/11 board turns green and the MC LED flashes whenthe system normally starts the booting process.y Once the booting is complete, the RUN LED of the MP10/11 board flashes green,and the SM LED stops flashing and remains lighted.y The RUN LED of the LCP board flashes when the power supply and processorstatus of the expansion rack is normal.If the Multi Media(MMC Card) is not detectedIf the system cannot detect the multi media, the MC LED of the MP10/11 board flashin red. In such cases, remove MMC card from MP10/11 boards and insert it again.4) Check if the LED statuses of other interface boards are normal.5) If the LED status of a MP10/11 or interface board is abnormal, turn off the power ofthe cabinet and turn the power on again.Board LED Status & Shut-down- Refer to the ‘OfficeServ 7100 System Manual’ for LED statuses of each board.- Shut-down is hardly required while operating the OfficeServ 7100 system.However, when shutting down the system due to reasons such as moving thesystem, turn off the power of the expansion cabinet, and turn off the power ofthe basic cabinet.