CHAPTER 8. Starting the System8-2 © Samsung Business Communications.8.2 Starting the System1) Check that all required modules and cables are properly mounted and connected to theOfficeServ 7400 chassis.2) Switch on the power to the OfficeServ 7400 basic chassis, and then switch on thepower to the expansion chassis.3) Check the LEDs of the MP40 and LP40 modules. The RUN LED on the MP40 module lights green and the SM LED flashes whenthe system starts the booting process. Once booting is complete, the RUN LED on the MP40 module flashes green, andthe SM LED stops flashing and lights steady. The RUN LED on the LP40 module flashes when the power supply and processorstatus of the expansion chassis is normal.If the Smart Media card is not detectedIf the system cannot detect the Smart Media card, the SM LED of the MCP mod-ule might not light or flash. In such cases, switch off the power to the basic chas-sis, replace the Smart Media card and switch the power on again.4) Check that the LED statuses of other interface modules are normal.5) If the LED status of a MP40, LP40 or interface module is abnormal, switch off the powerto the chassis and switch it on again.Module LED Status and Shut-down- Refer to the Samsung OfficeServ General Description for the LED statuses ofeach module.- Shut-down is rarely required while operating the OfficeServ system. However, ifshutting down the system for reasons such as moving it, switch off the power tothe expansion chassis first and then switch off the power to the basic chassis