English - 10Setting Up Anynet+The following settings help set the Anynet+ functions.Continued...To use the Anynet+ Function, Anynet+ (HDMI-CEC) must be set to On1 Press the MENU button. Press the ▲ or ▼ button to select Application, thenpress the ENTER button. Press the ▲ or ▼ button to select Anynet+ (HDMI-CEC), then press theENTER button. Press the ▲ or ▼ button to select On, then press the ENTER button.➢ The Anynet+ (HDMI-CEC) function is enabled.➢ If you select Off, Anynet+ (HDMI-CEC) is disabled.➢ When the Anynet+ (HDMI-CEC) function is disabled, all the Anynet+ relatedoperations are deactivated.Setting an Anynet+ Device to turn Off Automatically when the TV is Turned Off Press the ▲ or ▼ button to select Auto Turn Off, then press the ENTER button. Press the ▲ or ▼ button to select Yes, then press the ENTER button.➢ The Auto Turn Off function is enabled.➢ If you select No, the Auto Turn Off function is canceled.Press the EXIT button to exit.Scanning and Switching between Anynet+ Devices1 Press the TOOLS button.➢ Anynet+ devices connected to the TV are listed.➢ If you cannot find a device you want, press the red button to scan fordevices. Press the ▲ or ▼ button to select a particular device and press the ENTERbutton. It is switched to the selected device.➢ Only when you set Anynet+ (HDMI-CEC) to On in the Application menu,the Device List menu appears. If you cannot find a device you want, press the ▲ or ▼ button to selectSearching Connections, then press the ENTER button.The message Configuring Anynet+ connection... is displayed.When searching devices complete, the connected devices are listed in theAnynet+ menu.➢ The active source on the TV remote must be set to TV to use the Anynet+ function.➢ If you set Auto Turn Off to Yes, connected external devices are also turned off when the TV is turned off.If an external device is still recording, it may or may not turn off.➢ Switching to the selected devices may take up to 2 minutes. You cannot cancel the operation during the switchingoperation.➢ The time required to scan for devices is determined by the number of connected devices.➢ When the device scan is complete, the number of devices found are not displayed.➢ Although the TV automatically scans devices when it is turned on using the POWER button, devices connected whenthe TV is already on are not displayed in the device list. In this case, select the Searching Connections menu to searchdevices.➢ If you have selected an external device by pressing the SOURCE button, you cannot use the Anynet+ function. Makesure to switch to an external Anynet+ device by using the TOOLS button.WISELINKAnynet+ (HDMI-CEC) ►InfoLinkApplicationAnynet+ (HDMI-CEC)Anynet+ (HDMI-CEC) :Auto Turn Off :ReturnEnterMoveOffOnAnynet+ (HDMI-CEC)Anynet+ (HDMI-CEC) :Auto Turn Off :ReturnEnterMoveNoYesToolsMove EnterView TVDevice ListRecording : DVDDVD MenuDVD MenuPicture Mode : StandardSound Mode : CustomSleep Timer : OffAdd to Favorite ▼ExitBN68-01532A-Eng.indb 102 2008-04-18 오후 8:39:19
