English - 8Network Settings and InfoLinkNetwork Connection - CableLAN Connection for a DHCP EnvironmentThe procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IPaddress, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter themmanually.TV Rear PanelThe Modem Porton the WallModem CableExternal Modem(ADSL/VDSL/Cable TV) LANCable11 Connect the [LAN] porton the rear panel of theTV and the externalmodem with a LANCable.2 Connect the Modemport on the wall and theexternal modem with aModem Cable.TV Rear PanelThe Modem Porton the WallExternal Modem(ADSL/VDSL/Cable TV)IP SharerLANCableModem CableTV Rear PanelLAN CableYou can connect the LAN port and the TV directly depending on your network status.The LAN Porton the WallYou can connect the LAN via a Sharer (Router).The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10seconds and then try again.For the connections between the external modem and the Sharer (Router), refer to the owner’s manual of the correspondingproduct.You can connect the TV to the LAN directly without connecting it through a Sharer (Router)You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an automatic-connection-type ADSL modem.➣➣➣➣➣To access Samsung’s Infolink network feature, you must make one of the connections on the following pages.BN68-01532A-Eng.indb 89 2008-04-18 오후 8:38:57
