Samsung PS-42C6H Owner's Instructions Manual

English - 29How to Install the Wall Mount Bracket3 Tighten the screws of the plastic hanger (shownin picture 2) to the back side of the PDP.4 Remove the Safety Pins. Fasten the 4 plasticlatches assembled at step (#) on the back side ofthe PDP using the guide holes of the wall mount,push (!) and hook (@) down to secure the PDP onthe wall mount as illustrated. Secure the PDP byinserting the Safety Pins, not to fall from the wallmount.PDP panelWall attachmentpanel bracketWallHow to Adjust Mounting Angle➢ Please secure the mounting bracket on the wall surface after setting its angle at 0°1 Secure the SET to the wall mount bracket.(Please refer to thefollow ing instructions.)2 Set the angle by pulling the upper end of the SET attached tobracket in the direction of the arrow. (Refer to the illustrationon the right.)3 The angle can be adjusted from 0° to 15° by ±2°.Hold onto the middle of the PDP toadjust the angle (not the sides ofthe PDP).Connecting External Devices to the PDP➢ To connect external devices such as a DVD or a Home Theater System to the PDP, please refer to followinginstructions:1 Be sure to remove the safety pins underneath the PDP.➢ If the safety pins are not removed, the angle cannot beadjusted. Any attempt to do so may cause damage tothe PDP.2 Hold onto the bottom of the PDP and pull forward fully asdirected by the arrow as illustrated) to adjust the angle.(0°~20° by 2°) Insert the Safety Pins to the front guideholes on both sides as illustrated in figure @.➢ Viewing the PDP after connecting the external devicesRemove the Safety Pins to adjust the angle to 0°, andthen secure the Safety Pins again.☛ For safety, be sure to secure the PDP using the safetypins. If the safety pins are not used, the PDP may fall,causing serious injury.