Samsung PS-42C7HD Owner's Instructions Manual

Contents

English - 13Fine Tuning Channel ReceptionIf the reception is clear, you do not have to fine tune the channel, as this is doneautomatically during the search and store operation.If the signal is weak or distorted, you may have to fine tune the channel manually.1 Press the MENU ( ) button to display the menu.2 Press the … or † button to select Channel, then press the ENTER/OK ( )button.3 Press the … or † button to select Fine Tune, then press the ENTER/OK ( ) button.4 To obtain a sharp and clear picture and good sound quality, press the œ or √ button until you reach the optimalsetting. Press the ENTER/OK ( ) button.➢ To reset the fine tuning to 0, select Reset by pressing the … or † button.Press the ENTER/OK ( ) button.5 Press the EXIT button to exit.➢ Fine Tune Store will change the colour of the Channel OSD (On Screen Display) from White to Red andadd the “*” mark.P 1 *MonoP 1 *+3ResetFine TuneAdjust Save Return➢ Not available in DTV or external input mode.1 Press the MENU ( ) button to display the menu.2 Press the … or † button to select Channel, then press the ENTER/OK ( )button.3 Press the … or † button to select LNA, then press the ENTER/OK ( ) button.4 Select Off or On by pressing the … or † button, then press the ENTER/OK ( ) button.5 Press the EXIT button to exit.➢ Depending on areas, factory mode of LNA, will be set up as On or Off.LNA (Low Noise Amplifier)This function is very useful in the situation that the TV is used in weak signal.LNA amplifies the TV signal in the weak signal area, a low-noise preamplifierboosts the incoming signal.ChannelMove Enter ReturnCountry : BelgiumAuto StoreManual StoreChannel ManagerSortNameFine TuneLNA : OffTVYou can select the type of picture which best corresponds to your viewingrequirements.1 Press the MENU ( ) button to display the menu.2 Press the … or † button to select Picture, then press the ENTER/OK ( )button.3 Press the ENTER/OK ( ) button twice.4 Select the required mode by pressing the … or † button, then press theENTER/OK ( ) button.Available modes: Dynamic, Standard, Movie, Custom➢ The settings values may vary depending on the input source. (ex. RF, Video, Component, PC, or HDMI)5 Press the EXIT button to exit.➢ You can select these options simply by pressing the P.MODE button on the remote control.➢ ◆ Choose Dynamic for viewing the TV during the day or when there is bright light in the room.◆ Choose Standard for the standard factory settings.◆ Choose Movie when viewing the movie.◆ Choose Custom if you want to adjust the settings according to personal preference.Changing the Picture StandardModeMove Enter ReturnMode : DynamicContrast 100Brightness 50Sharpness 75Colour 55Tint G 50 R 50Colour Tone : Cool1ResetTVDynamicStandardMovieCustom