English - 111 Remove the 4 screws on the back of the product.3 Tighten the 4 screws in step 2 (plastic hanger+ screw ) to the rear holes of the product.2 Insert the screw into the plastic hanger.(See the figure below)☛ ◆ Mount the product on the wall bracketand make sure it is properly fixed tothe left and right plastic hangers.◆ Be careful when installing the producton the bracket as fingers can becaught in the holes.◆ Make sure the wall bracket is securelyfixed to the wall, or the product may notstay in place after installation.4 Remove safety pin (#) and insert the 4 productholders into the corresponding bracket holes (!). Thenplace the product (@) so that it is firmly fixed to thebracket. Make sure to reinsert and tighten the safetypin (#) to securely hold the product to the bracket.Wall Bracket Angle Adjustment➢ Adjust the bracket angle to -2o before installing it on the wall.◆ The shape of the product may vary depending on the model. (The assemblies of the plastic hangerand the screw are the same)PDPWall Bracket Wall1 Fix the product to the wall bracket.2 Hold the product at the top in the center and pull itforward (direction of the arrow) to adjust the angle.(See the figure to the right)3 You can adjust the bracket angle between -2° and 15°.Make sure to use the top center,and not the left or the right side ofthe product to adjust the angle.To mount the product on the wall bracket
