Samsung PS42Q91H Owner's Instructions Manual

Contents

Samsung PS42Q91H Owner's Instructions Manual Manual pdf 38 page image

English - 38Listening through a ReceiverYou can listen to sound through a receiver instead of the TV speaker.1 Press the Anynet+ button.Press the ▲ or ▼ button to select Receiver, then press theENTER button.2 Press the ◄ or ► button to select to On, then press theENTER button.Now you can listen to sound through the receiver.3 Press the EXIT button to exit.➢ When the receiver is set to On, you can listen to the TV soundthrough the 2-channel receiver.➢ If the receiver is exclusively for a home theater only (supportingaudio only), it may not appear in the device list.➢ In case of a content with copyright problem, listening through the receiver may not properly operate.➢ When listening through the receiver, there are restrictions for using the PIP and audio-related menu.Check Points before Requesting ServiceSymptom SolutionAnynet+ does not work. ■ Check if the device is an Anynet+ device. The Anynet+ systemsupports Anynet+ devices only.■ Connect only one receiver.■ Check if the Anynet+ device power cord is properly connected.■ Check the Anynet+ device’s Video/Audio/HDMI cable connections.■ Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+setup menu.■ Check whether the TV remote control is in TV mode.■ Check whether it is Anynet+ exclusive remote control.■ Anynet+ doesn’t work at a certain condition. (Searching channels)■ When connecting or removing the HDMI cable, please make sureto search devices again or restart your TV.■ Check if the Anynet+ Function of Anynet+ device is set on.I want to start Anynet+. ■ Check if the Anynet+ device is properly connected to the TV andcheck if the Anynet+ (HDMI-CEC) is set to On in the Anynet+ Setupmenu.■ Press the TV button on the TV remote control to switch to TV. Thenpress the Anynet+ button to show the Anynet+ menu and select amenu you want.I want to exit Anynet+. ■ Select View TV in Anynet+ menu.■ Press the SOURCE button on the TV remote control and select adevice other than Anynet+ devices.■ Press any of CH, CH LIST, and PRE-CH to change to theTV mode. (Note that the channel button operates only when atuner-embedded Anynet+ device is not connected.)The Connecting to Anynet+device… message appearson the screen.■ You cannot use the remote control when you are configuringAnynet+ or switching to a view mode.■ Use the remote control when the Anynet+ setting or switching toview mode is complete.The Anynet+ device doesnot play. You cannot use the play function when Plug & Play is in progress.The connected device is notdisplayed.■ Check whether or not the device supports Anynet+ functions.■ Check whether or not the HDMI cable is properly connected.■ Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+setup menu.■ Search Anynet+ devices again.■ You can connect an Anynet+ device using the HDMI cable only.Some HDMI cables may not support Anynet+ functions.The TV program cannot berecorded. Check whether the antenna jack on the recording device is properlyconnected.EnterMoveView TVSelect Device Record Menu on Device Device Operation Receiver :On Setup TV P 1Exit