Samsung RF263BEAESR User Manual

Also see for RF263BE Series: User manual User manual User manual

10_ setting upPull out the freezer drawer (1. 1 ), then you cansee the lower hinge ( 2 ).Insert the supplied allen wrench (3/16”) (2. 3 )into the shaft ( 4 ) of the lower hinge.Please adjust the height by turning the3.hex wrench ( 3 ) clockwise ( DOWN ) orcounterclockwise ( UP ).When you turn the hex wrench counter-clockwise( ), the door will move up.After adjusting the doors, insert the supplied4.fastener ( 6 ) using a pliers ( 5 ) in the gapbetween the hinge-grommet ( 7 ) and the lowerhinge ( 8 ). The number of fasteners you’ll needto insert depends on the gap.2 fastener are enclosed with the refrigerator.The thickness of each fastener is 0.04”.INSTALLING ThE WATERDISPENSER LINEA water dispenser with a filter is one of the helpfulfeatures on your new refrigerator. To help promotebetter health, the water filter removes unwantedparticles from your water. However, it does notsterilize or destroy microorganisms. You may needto purchase a water purifying system to do that.In order for the ice maker to operate properly, awater pressure of 20~125psi ( 138~862kPa) isrequired.Under normal conditions, a 170 cc (5.75 oz.) cupcan be filled in about 10 seconds.If the refrigerator is installed in an area with lowwater pressure (below 20psi), you can installa booster pump to compensate for the lowpressure.After you have connected the water line, makesure the water storage tank inside the refrigeratoris properly filled. To do this, press the waterdispenser lever until the water runs from the wateroutlet.Water line installation kits are available atextra cost from your dealer.We recommend using a water lineinstallation kit that contains copper tubingand ¼” compression nut.Connecting to the water supply lineFirst, shut off the main water1.supply.Locate the nearest cold water drinking line and2.install the pipe clamp and shut off valve.Connect the water line installation kit to the3.shut off valve.Connecting the water supply line tothe refrigerator.There are several items that you need to purchaseto complete this connection.You may find these items sold as a kit at your localhardware store.use copper tubing use Plastic tubing¼” copper tubing•¼” compression nut (1pc)•Ferrule (2pc)•¼” plastic tubing•→ Molded end(Bulb)¼” compression nut (1pc)•Pipe clampcold water lineShut off valveShut off valvePipe clampcold water lineWater line installation kit31234DA68-02601A(EN+FR+ES)-0.2.indb 10 2012.3.31 9:49:43 AM