Samsung RFG297AC Series User Manual

Setting Up _901 sEttinG uPDisassemble the Refrigerator doors1. With the door opened, remove the Hinge Covercap ( 1 )with a Flat head screwdriver, and closethe door.Remove the 3 screws holding down the HingeCover and remove the Hinge Cover ( 2 ).21REMoVinG tHE REFRiGERAtoR DooRsIf the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.tools you will needPhilips screwdriver Flat-blade screwdriver Wrench(10mm) Pliers Allen wrench(3/16”)(5mm)sEttinG uP tHE REFRiGERAtoRNow that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features andfunctions of the appliance. By completing the following steps, your Refrigerator should be fully operational.1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and theRefrigerator. Refer to installation instructions in this manual.2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightlychilled and the motor will run smoothly.4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You canstore food and drinks in the Refrigerator after the temperature is sufficiently cool.Check the accessory list below.Water filter(DA29-00003B)Hex wrench(DA80-00002C)Compression fitting(DA62-00305A)Compression nut(DA74-00070B)Fastener(DA60-00143B)