53TROUBLESHOOTING4-1-4. Display function of Load condition1) If Freezer Key + Fridge Key are pressed simultaneously for 6 seconds during normal operation, thetemperature setting display of fresh food and freezer compartments will blink ALL ON/OFF with 0.5 for4 seconds.2) At this moment, If Alarm Key after Freezer Key + Fridge Key is pressed, load condition display modewill be returned with alarm. At LED all on state, only load condition display will blink ON/OFF with 0.5seconds interval.3) Load condition display mode shows the load that micom signal is outputting.However, It means that micom signal is outputting, it does not mean whether load is operating or not.That is to say that though load operation is displayed, load could not be operated by actual load erroror PCB relay error etc. (This function would be applied at A/S.)4) Load condition display function will maintain for 30 seconds and then normal condition will be returnedautomatically.5) Load condition display is as below. Only the load control LED will blink with 0.5interval in "Display LED"If Freezer Key + Fridge Key are pressed simultaneously for 6 seconds, ALL ON/OFF will blink with0.5interval for 4 seconds.If take the finger off from above keys and press Alarm, load condition mode will be started.F-1F-10 R-1R-10
