Samsung RIF-BT10 User Manual
                 | |
V1.00 WWW.SAMSUNGMINIPRINTERS.COM 15The below terms explains each item reading at Configure adapter1) Bluetooth address- Individual address of each Bluetooth module.2) Firmware version- Bluetooth firmware version.3) Role- Selection of Master/Slave.4) Baud rate- Transmission speed setting.5) Flow control- Handshaking condition setting.6) Auto connect to printers- Auto connection to the designated Bluetooth slave.- Applicable when the designated printer (Bluetooth slave) used.- When the multiple printers installed, simultaneous printing becomes available.- It ignores the printer in Power off mode.- The data transmission stands by when any of the registered printers goes on Busy mode suchas no paper, cover open, buffer full etc until it recovers.- With no use of this option, Application program should send data only after it connected toBluetooth slave by Control message. This can be used when wanted to use the designatedone out of several printers7) Wait for all connected- It is available only when Auto connect to printers selected.- Under the condition of several Bluetooth slave saved in Bluetooth master, it transmits the datathoroughly until the all the registered printers complete the reception.8) Printer name- You can set the printer name less than 15 letters.9) Auto detect- It is to read the individual printer name such as SRP-350 etc.- It is available only when the printer has the individual name.10) Printer location- It is to set the location identity of the printer such as Kitchen PRT 1 or Receipt PRT 1 lessthan 12 letters.11) Print F/W info- Printer prints the firmware data of Bluetooth slave module at printer power on. |
Related manuals for Samsung RIF-BT10
manualsdatabase
Your AI-powered manual search engine