Samsung RIF-BT10 User Manual

Contents

V1.00 WWW.SAMSUNGMINIPRINTERS.COM 65) Bluetooth master setting- Connect Bluetooth main (master/slave) to USB (or Serial) port of PC.- Execute BluetoothConfig_V2.x.exe from the downloaded files.- Select the porta) USB port: Select the virtual port (COM x) of step 2).b) Serial (RS-232C): Select the COM x connected.- Configure Adapter setting: master, 19200, hardware- Register Printer setting: Search the printers around and save the printer address bybutton “Search”. Make sure the printers are all power on mode.- Configure Adapter setting: Check in auto connector to printers.- Click “ok”.- Refer to Attachment 5. Bluetooth master Setting6) Printer driver installation & Test page printing- Once the setting’s complete, disconnect the Bluetooth master from the PC, reconnect it and initializethe system. Turn the printer off and then on to initialize the Bluetooth slave.- Wait for approximately 20 seconds for the Bluetooth master and slave are automaticallyreconnected.- Install the printer driver (Available at website)a) SRP 350: V3.0.5E aboveb) SRP 270: V3.0.3E above- You can download the printer driver from the homepage. Make sure that you delete the older versiondriver from the PC before you install the new one(Clean register)- Open the printer driver and select a porta) USB port: Select the virtual port (COM x) of step 2).b) Serial (RS-232C): Select the COM x connected.- Set the port settings as below (19200, 8, none, 1, hardware)- Test Page Printing.- Refer to Attachment 6. Test page printing7) Other- If you are a POS Application Programmer, refer to the manual below for more information.: “Bluetooth control message V1.x