English - 12Separating the water supply line fromthe refrigerator1. Remove the water tube by pressing the coupler( 1 ) and pulling the water tube ( 2 ) away.(1)(2)CAUTIONDo not cut the water line.Gently separate it from the coupler.Re-attaching the Water Supply Lines1. The Water Lines must be fully Inserted into thecenter of the transparent coupler to preventwater leakage from the dispenser.2. Insert the 2 clips in the install pack as shownbelow, and then confirm that each clip holdsthe line firmly.Center of Transparent couplerClip A (1/4”)(6.35 mm)CAUTIONMake sure the color of the water lines match.Removing the freezer doorA few things to mention first.• Make sure that you lift the door straight up sothe hinges are not bent or broken.• Be careful not to pinch the water tubing andwire harness on the door.• Place doors on a protected surface to preventscratching or damage.• Is necesary two people for disassemblingdoors.1. With the Freezer door closed, remove theupper hinge cover ( 1 ) using a screwdriver, andthen disconnect the wires ( 2 ).(2)(1)Be careful, no damage sensor harnesswith cover hinge.2. Remove hinge bolts ( 3 ) and a ground screw( 4 ) counter-clockwise, and take off the upperhinge ( 5 ) in the direction of the arrow.Be careful when removing the door to ensurethat it does not fall on you.(4)(3)(5)Pressing3. Before remove the bolts, disassembling CoverLeg front and hoses.Remove the door from the lower hinge ( 6 ) bycarefully lifting the door ( 7 ).(7)(6)DA68-02981E-00.indb 12 13. 12. 12. �� 3:07