20_ setting upsetting up your side-by-side refrigeratorinstaLLing the water DisPenser LineConnecting the water line to the Refrigerator.There are several items that you need to purchase to complete this connection.You may find these items sold as a kit at your local hardware store.• 1/4” compression nut • plastic tubing• copper tubing • ferrule1. Slip the compression nut through the supplied plastic tubing .2. Tighten the compression nut onto the 1/4” compression fitting.- If you are using copper tubing, slip the compression nut (not included) and ferrule (not included)on copper tubing (not included) as shown.- If you are using plastic tubing , insert the molded end(Bulb) of the plastic tubing into thecompression fitting.Do not use without the molded end(Bulb) of the plastic tubing .3. Tighten the compression nut onto the compression fitting. Do not over-tighten the compression nut .4. Turn water on and check for any leakage.Only connect the water line to a drinkable water source.If you have to repair or disassemble the water line, cut off 1/4” of the plastic tubing to make sureyou get a snug, leak-free connection.When using power cordTo prevent power cord damage, after product installation, arrangethe remaining power cord to the unit cover and fix.Non operation During operationCAUTIONPlastic tubing(Supplied)Ferrule(Not supplied)Compression nut(1/4”) (Supplied)Compression fitting(Supplied)BulbCompression nut(1/4”) (Not supplied)Copper tubing or Plastic tubing(Not supplied) (Not supplied)household water linerefrigerator