Samsung RS26DDA series User Manual

Also see for RS26DDA Series: User manual

20_setting upRemoving r1. Turn ON the main water supply.2. Press the Water button and push the dispenser pad.Refer to ‘Checking the control panel’ in the manual (page 20)3. Flush 3 gallons of water thr(Flush approximately 6 minutes.)This will clean the water supply system and remove air from the lines.4. equired in some households.5. Open the refrigerator door and make sure there are no water leaks comingfr .om the water dispenser. This is due to airgetting into the line. It should pose no problem to operation.Check the amount of water supplied to the ice tray1. Lift up and pull out the Ice maker bucket in the freezer.2. When you press the Test button for 3 seconds,omthe water supply tap. Put a bowl before youpress the test button and check to makesure the amount of water is correct (see theillustration). If the water level is too low, the icecubes will be small. This is not a problem withthe ice maker but of the water pressure in thepipe.3. In case ice does not come out, pull out the ice bucket andpress test button located on the bottom of ice maker.LOCKIce Watersetting up your side-by-side refrigerator