Samsung RSA1V Series User Manual

setting up _2setting up your side-by-siderefrigeratorRemoving any residual matter inside the water supply line afterinstalling filter.1. Turn ON the main water supply & turn OFF the valveto the water supply line.2. Run water through the dispenser until the water runsclear (approx. 1L). This will clean the water supplysystem and remove air from the lines.3. Additional flushing may be required in somehouseholds.4. Open the refrigerator door and make sure there areno water leaks coming from the water filter.A newly installed water filter cartridge may causewater to briefly spurt from the water dispenser. Thisis due to air getting into the line. It should pose noproblem to operation.Check the amount of water supplied to the ice tray. (Optional)1. Lift up the icemaker bucket and gently pull out of the freezer.2. When you press the Test button for 1.5 seconds, the ice cube container is filled with waterfrom the water supply tap after ice tray is twisted. Check to make sure the amount of water iscorrect(see the illustration below).If the water level is too low, the ice cubes will be small. This is a water pressure problem fromwith in the main water pipes, not the refrigerator.10 SE GNITT UPIce maker1Ice Water2Check the water levelTest buttonFeeler Arm