operating the SAMSUNGside-by-side refrigeratorsEtting uP tHE rEfrigEratorNow that you have your new refrigerator installed and in place, you are ready to set up and enjoy the fullfeatures and functions of the appliance.By completing the following steps, your refrigerator should be fully operational. If not, first check the powersupply and electricity source or try the troubleshooting section at the back of this user guide. If you haveany further questions, contact your Samsung Electronics service center.1. Place the refrigerator in an appropriate location with reasonable clearance between the walland the refrigerator. Refer to installation instructions in this manual.. Once the refrigerator is plugged in, make sure the interior light comes on when you open thedoors.. Set the temperature control to the coldest temperature and wait for an hour.The freezer should get slightly chilled and the motor should run smoothly.. After powering the refrigerator, it will take a few hours to reach the appropriate temperature.Once the refrigerator temperature is sufficiently cool, you can store food and drink in therefrigerator.0_ setting upPull out the ice tray.Pour cool water into thetray until it reaches thewater level indicator onthe tray.Place it inside ice tray.Turn ice tray button and theice automatically full intothe below ice compartmentafter release. Pull out icestorage compartment for ice.Pull out the ice tray.Pour water into the trayuntil it reaches the waterlevel indicator on the tray.Place it under the freezershelf or on the freezer shelf.To separate individual icecubes, pull out the ice trayand hold the ice tray by itsends, then twist it gently.When the freeze temperature get zero degre below, you can use Ice Box to make ice.USE ICE TRAY(OPTIONAL)(RSA1Z,RSA1S,RSA1U,RSA1D,RSA1N,RSA1V,SRS582NLS,SRS565DHLS)