setting up _15ChECKinG thE wAtER DiSPEnSER LinEA water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote betterhealth, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize ordestroy microorganisms. You may need to purchase a water purifying system to do that.In order for the ice maker to operate properly, a water pressure of 20~125 psi (pound per square inch) isrequired. Under normal conditions, a 170 cc (5.75 oz.) paper cup can be filled in 10 seconds.If the Refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump tocompensate for the low pressure.Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenserlever until the water runs from the water outlet.Water line installation kits are available at extra cost from your dealer. We recommend using a water supplykit that contains copper tubing.Connecting to the water supply line1. First, shut off the main water supply line and turn the ice-maker off.2. Locate the nearest cold, drinking water line.3. After connecting the water supply to the water filter, turn your main water supply back on and flush fouror more gallons into a bucket to clear and prime the water filter.01 SEttinG uP1 Cold water line2 Pipe clamp3 Water line installation kit4 Shut off valveDA99-01746A(EN)-GGH.indd 15 2008.7.10 12:12:47 PM