setting up _174. Remove the filter cap and insert the filterinto the filter housing.5. Slowly turn the water filter 90º clockwiseto align with the printing mark on thecover, locking the filter in position. Makesure to align the water filter label markwith center of cover filter printing asillustrated. Remember, do not over-tighten.Removing any residual matter inside the watersupply line after installing filter.1. Turn ON the main water supply.2. Press the water button and push the disperser pad.3. Run water through the dispenser until the water runs clear (approx.3L). This will clean the water supply system and remove air from thelines.4. Additional flushing may be required in some households.5. Open the refrigerator door and make sure there are no water leakscoming from the water filter.A newly installed water filter cartridge may cause water to brieflyspurt from the water dispenser. This is due to air getting into theline. It should pose no problem to operation.Check the amount of water supplied to the ice tray.1. Lift up the icemaker cover and gently pull it out.2. When you press the Test button for 3 seconds, the ice cube container is filled with water from thewater supply tap. Check to make sure the amount of water is correct(see the illustration below).If the water level is too low, the ice cubes will be small. This is a water pressure problem fromwithin the main water pipes, not the refrigerator.- It will take a few minutes to reach the amount of water you want.- Do not press the test button continuously when the tray is filled with ice or water.Water may overflow or ice jamming may occur.- When the bucket is not installed, the ice maker does not work.- When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’sinstalled properly.CAUTION01 SEttinG uPCover filterAlign the indicationmark with lock positionSeparationof red cap4 5watericeice maker1test buttonCheck the water level2DA99-01746B(EN-1)-GGH.indd 17 2008.7.24 2:52:39 PM