2_ OperatingBEfoRE uSinG iCEMAKERRemove- Hold the handle as shown in figure1.- Slightly pull up the bottom part.- Take out the ice bucket slowly.Install- Assemble it in the reverse order of disassembly.- Push the bucket in firmly until you hear a clicking sound.- When the bucket does not fit into its place, turn the gear handle on its backby 90 degrees and reinstall it again as shown in figure 2.Before calling service- Any sounds you hear when the ice maker dumps ice into the bucket are partof normal operation.- Not dispensing ice for long periods may cause ice clumps in the ice bucket.Remove the remaining ice and empty the bucket.- When ice does not come out, check the ice stuck in the chute and remove it.- When ICE OFF blinks on the display panel, reinsert the bucket and/ormake sure it’s installed properly.- When the door is open, the Ice and water dispenser do not work.- If you close the door hard, it may cause water spilling over the icemaker.- To prevent dropping the ice bucket, use both hands when removing it.- To prevent injury, be sure to clean up any ice or water that may havedropped on the floor.- Do not let the children hang on the ice dispenser or on the bucket.They may get hurt.- Be sure not to put your hand or any object into the ice chute.It may cause personal injury or damage mechanical parts.90。90。Figure2Ice ChuteFigure1CAUTIONDA99-01746B(EN-1)-GGH.indd 28 2008.7.24 2:52:50 PM