Samsung RSG307 SERIES User Manual

Also see for RSG307 SERIES: Quick start guide User manual User manual User manual

setting up _0701 SETTING UPSETTING UP THE REFRIGERATORDOORSIf your entrance won’t allow the refrigerator to passeasily through it, you can remove the doors.Separating the Water Supply Line from theRefrigerator1. Pull the two water lines (which are in the Fixer) outto the front.2. Remove two water lines (White one is for waterand the other one is for ice) by pressing thecoupler 1 and pulling the water line 2 away.Removing the freezer doorA few things to mention fi rst.• Make sure that you lift the door straight up so thehinges are not bent or broken.• Be careful not to pinch the water tubing and wireharness on the door.• Place doors on a protected surface to preventscratching or damage.1. Remove a screw on the upper hinge cover 1 .With the door open, disengage the two lockingtabs with a fl at-head screw driver 2 and removeit while the lifting up the rear of the cover 3 , andthen disconnect the wires by gently pulling themapart 4 .2. Removing the FIXER HINGE ,and next take off theupper hinge. Be careful that the door does not fallon you as you are removing it.Be sure to keep track of all parts you areremoving.3. Next, remove the door from the lower hinge 5 bycarefully lifting the door straight up 6 .Be careful not to pinch the water tubing andwire harness on the door.Reattaching the freezer doorsTo reattach the freezer doors, replace parts in reverseorderReattaching the Water Supply Line1. The Water Line must be fully Inserted to the centerof transparent coupler to prevent water leakagefrom the dispenser.2. Insert the 2 clips in the install pack and check thateach clip holds the line fi rmly.Do not cut the water line. Gently separate itfrom the coupler.12Make sure the color ofMake sure the color ofthe water lines match.the water lines match.65Center of transparent couplerCenter of transparent couplerclip A (¼”)clip A (¼”)(6.35mm)(6.35mm)4321