Samsung RSH5SBBP User Manual

Also see for RSH5SBBP: User manual Quick guide Quick start guide

Contents

setting up _1501 SETTING upConnect the water line to therefrigerator.- Remove the compressor cover of the refrigerator.- Connect the water line to the valve, as shown inthe figure.- When connected, check if there is any leakage.If any, repeat the connection.- Reattach the compressor cover of the refrigerator.Secure the water line.- Using clip ”A”, fix the waterline to the wall (the back ofrefrigerator).- When the water line issecure, make sure whetherthe water line is notexcessively bent, pinched orsquashed.Removing any residual matter insidethe water supply line after installingfilter.1. Turn ON the main water supply & turn OFF thevalve to the water supply line.2. Run water through the dispenser until the waterruns clear (approx. 1L). This will clean the watersupply system and remove air from the lines.3. Additional flushing may be required in somehouseholds.4. Open the refrigerator door and make sure thereare no water leaks coming from the water filter.A newly installed water filter cartridge may causewater to briefly spurt from the water dispenser.This is due to air getting into the line. It shouldpose no problem to operation.Check the amount of water suppliedto the ice tray.1. Lift up the icemaker cover and gently pull out.2. When you press the Test button for 3 seconds,the ice cube container is filled with water from thewater supply tap. Check to make sure the amountof water is correct (see the illustration below).If the water level is too low, the ice cubes will besmall. This is a water pressure problem from within the main water pipes, not the refrigerator.WATER LINEINSTRUCTIONSCOMPRESSOR COVER OFREFRIGERATORCONNECTION NUTCLIP AWATER LINEIce maker1Feeler Arm2 Test buttoncheck the water level