setting up _1501 SETTING UPConnect the water line to therefrigerator.- Remove the compressor cover of the refrigerator.- Connect the water line to the valve, as shown inthe fi gure.- When connected, check if there is any leakage.If any, repeat the connection.- Reattach the compressor cover of the refrigerator.Secure the water line.- Using clip ”A”, fi x the waterline to the wall (the back ofrefrigerator).- When the water line issecure, make sure whetherthe water line is notexcessively bent, pinched orsquashed.Removing any residual matter insidethe water supply line after installingfi lter.1. Turn ON the main water supply & turn OFF thevalve to the water supply line.2. Run water through the dispenser until the waterruns clear (approx. 1L). This will clean the watersupply system and remove air from the lines.3. Additional fl ushing may be required in somehouseholds.4. Open the refrigerator door and make sure thereare no water leaks coming from the water fi lter.A newly installed water fi lter cartridge may causewater to briefl y spurt from the water dispenser.This is due to air getting into the line. It shouldpose no problem to operation.WATER LINEINSTRUCTIONSCOMPRESSOR COVER OFREFRIGERATORCONNECTION NUTCLIP AWATER LINE