18_ setting up4. Remove the filter cap and insert thefilter into the filter housing.5. Slowly turn the water filter 90ºclockwise to align with the printingmark on the cover, locking the filterin position. Make sure to align thewater filter label mark with centerof cover filter printing as illustrated.Remember, do not over-tighten.Removing any residual matter inside the watersupply line after installing filter.1. Turn ON the main water supply.2. Press the Water button and push the dispenser pad.3. Run water through the dispenser until the water runs clear(approx. 3L). This will clean the water supply system andremove air from the lines.4. Additional flushing may be required in some households.5. Open the refrigerator door and make sure there are no waterleaks coming from the water filter.A newly installed water filter cartridge may cause water tobriefly spurt from the water dispenser. This is due to airgetting into the line. It should pose no problem to operation.Check the amount of water supplied to the ice tray.1. Lift up the icemaker cover and gently pull out.2. When you press the Test button for 3 seconds, the ice cube container is filled with waterfrom the water supply tap. Check to make sure the amount of water is correct(see theillustration below).If the water level is too low, the ice cubes will be small. This is a water pressure problem fromwith in the main water pipes, not the refrigerator.- It will take a few minutes to reach the amount of water you want.- Do not press the test button continuously when the tray is filled with ice or water asillustration below. Water may overflow or ice jamming may occur.- When the bucket is not installed, the ice maker does not work.- When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’sinstalled properly.Cover filteralign the indicationmark with lock positionseparationof red cap4 5ice maker1test buttonCheck the water level2CAUTIONwaterice