operating _4702 OPERATINGWhen the Flex Zone or LED lighting is notworking, check the connectors [ ( 1 ), ( 2 )shown below ] for cracks or leaks.121. Refer to page 19 for disassemblyinstructions.2. Open the cap cover rail with a fl at-blade screwdriver.Using the doorsEnsure that the doors close all the way and aresecurely sealed.When the refrigerator door is only partially open, itwill automatically close. If the the door is openedmore than its auto close range, it will remain open.You must close it manually.REMOVING THE FREEZERACCESSORIES1. Freezer Room GuardTo remove - Remove the freezer room guard ( 1 )by lifting the guard up.To re-install - Push down until the guard ( 1 )locks into place.12. Super Extended DrawerTo remove - Pull the drawer out to full extension.Tilt up the rear of the drawer and lift straight out.To re-install - Place the drawer onto the rails ( 4 )by tilting it up. Lower the drawer into place until itis horizontal and slide the Drawer ( 3 ) in.343. Freezer DrawerTo remove the freezer drawer - Pull the freezerdrawer out fully. Tilt up the rear of the bin and lift itout to remove.To re-install the freezer drawer - Place the bininto the rail assembly.Do not allow babies or children go insidethe freezer drawer. They could damagethe refrigerator and seriously injurethemselves. Do not sit on the freezer door.The door may break. Do not allow childrento climb into the freezer drawer.Do not remove the divider.If trapped inside, children may be injuredor suffocate to death.CAUTIONCAUTIONWARNING