setting up _1301 SETTING UPAfter connecting the water supply to the water4.fi lter, turn your main water supply back on anddispense about 1l to clear and prime the waterfi lter.Connecting the water line to therefrigeratorRemove the dust cap from the water line on the1.rear of the unit and fi t a compression nut fromthe install kit.Remove the water pipe from the install kit and2.fi t a compression nut to one end.Join the two pipes together using the3.compression joint from the install kit ensuringthat the joint is water tight.Join the other end of the install pipe to the main4.water supply and turn on the water to check forleaks.Only connect the water line to a drinkablewater source.If you have to repair or disassemble thewater line, cut off 6.5 mm of the plastictubing to make sure you get a snug, leak-free connection.Before being used, the leakage in theseplaces should be examinedCAUTIONSamsung Warranty does not cover WATER•LINE INSTALLATION.The cost of connection to a water supply is at•the customer expense, unless included in thedelivery charge (refer to the delivery agreementwith the seller)Please contact Plumber or Authorised Installer•for the installation if needed.If Water leakage occurs due to improper•installation, Please contact installer.INSTALLING THE WATERDISPENSER LINEFor Exterior modelParts for water line InstallationConnecting to the water supply lineConnect the water pipe with coupler and tap.Close the main water tap.1.Connect coupler “A” to the tap.2.Close MainClose MainWater pipeWater pipeClose MainClose MainWater pipeWater pipeNo gapNo gapWater line fixer and screwsWater line fixer and screwsPipe connectorPipe connectorWater lineWater line Purifier lock-clipPurifier lock-clip PurifierPurifierRemoveRemovecapcapWater Line fromWater Line fromunitunitWater Line fromWater Line fromKitKitNo gapNo gapLoosen aLoosen aCAUTIONThe water line must be connected to the cold waterpipe. If it is connected to the hot water pipe, it maycause the purifi er to malfunction.