Adjusting the LCD during PLAY✤ You can adjust the LCD during playback.✤ The adjustment method is the same procedure as used in CAMERA mode. (see page 31)The Speaker works in PLAYER mode only. When you use the LCD screen for playback, you can hear the recorded sound fromthe built-in Speaker.- Follow the instructions below to decrease or mute speaker volume in the PLAYER mode.- Take the following steps to lower the volume or mute the sound while playing a tapeon the camcorder.1. Set the power switch to PLAYER mode.2. Press (PLAY/STILL) to play the tape.3. When you hear sounds once the tape is in play, use the MENU DIAL to adjust the volume. A volume level display will appear on the LCD.Levels may be adjusted from anywhere between 00 to 19 and you will not hearany sound when the volume is set on 00. If you close the LCD while playing, you will not hear sound from the speaker.Notes When the cable is connected to the A/V jack, you cannot hear sound from the speaker andcannot adjust the volume. You can hear sound from speaker by removing the connected cable from the A/V jackENGLISHBasic Recording34340 : 2 3 : 4 75 5 min1 0 : 0 0 AMJ A N . 1 0 , 2 0 0 3VOL. [ 1 1 ]<3-2>Controlling Sound from the SpeakerVOL/MF23-1
