104Note: Speaking clearly, say the command that you want to use. If, after a few seconds, the device has notrecognized a command, it prompts you to repeat the command. If, after a few more seconds, it stillhas not recognized a command, it tells you “Sorry, no match found,” and cancels voice recognition.Voice Command Tips:• Make sure you wait for the beep before speaking.• Speak clearly at a normal volume, as if you were talking on the phone.Voice-Activating Your Contacts ListWhen you first start VoiceSignal, it reads your Contacts list and voice-activates allthe names stored there. When you have add or change contacts, VoiceSignalautomatically reloads and voice-activates the entire list.Ending Calls Before Restarting the VoiceSignal SoftwareWhen you use VoiceSignal to make a call, you must end that call before you can useVoiceSignal again.Voice MemoYou can use your phone to record voice memos for later playback. You can alsorecord the caller on the other end of the line during a phone conversation.Note: There is limited space for the number and length of recordings.• The maximum number of voice memos is 10.• The maximum length for a single voice memo is 60 seconds.Record a Voice Memo1. In standby mode, press the MENU (left) soft key ( ), then press(for Tools), (for Voice Kit), (for Voice Memo), and forRecord. The phone prompts, “Please record after the beep.”Tip: To launch Voice Memo using a voice command — In standby mode, press the key. When thephone prompts, “Say a command.” Say “Voice Memo” into the microphone.2. Wait for the beep, then start speaking. As it is recording the phone displaysa countdown timer that shows the seconds remaining for the recording.• To pause the memo, press the Pause (left) soft key ( ). When a memo ispaused, select Resume to resume recording.3. Press the Stop (right) soft key ( ) once you’re finished recording. TheMemo Review list appears in the display with the newest memohighlighted.tuvtuv@ abc @
