Wireless network setup 482. Using a network-connected machineBefore entering the IP address for the machine, you mustknow the computer’s network configuration information. Ifthe computer’s network configuration is set to DHCP, thewireless network setting should also be DHCP. Likewise, ifthe computer’s network configuration is set to Static, thewireless network setting should also be Static.If your computer is set to DHCP and you want to use Staticwireless network setting, you must contact the networkadministrator to get the static IP address.• For the DHCP methodIf the IP address assignment method is DHCP, check ifDHCP is shown in the Wireless Network Setting Confirmwindow. If it shows Static, click Change TCP/IP to changethe assignment method to Receive IP addressautomatically (DHCP).• For the Static methodIf the IP address assignment method is Static, check ifStatic is shown in the Wireless Network Setting Confirmwindow. If it shows DHCP, click Change TCP/IP to enterthe IP address and other network configuration values forthe machine.For example:If the computer’s network information is as shown follows:- IP address: 169.254.133.42- Subnet Mask: 255.255.0.0Then, the machine’s network information should be asbelow:- IP address: 169.254.133.43- Subnet Mask: 255.255.0.0 (Use the computer’s subnetmask.)- Gateway: 169.254.133.116 The wireless network connects according to the networkconfiguration.17 When the wireless network setting is completed, disconnectthe USB cable between the computer and machine.18 Follow the instructions on the screen to complete theinstallation. After the installation is finished, click Quit orRestart. 18Using a network cableYour machine is a network compatible machine. To enable yourmachine to work with your network, you will need to perform someconfiguration procedures.
