SENDING A FAX 2.726 If the SEND FROM MEMORY feature is set to ON (defaultsetting), the document is scanned into the memory and thedisplay shows the remaining memory capacity and thenumber of pages being stored in memory.If the document is fed from the document glass, the displayshows “ANOTHER PAGE?” on the top line after the documentis scanned into the memory. If you have the next page,remove the scanned page and load the next page on theglass and select “1.YES”. Repeat as necessary.When all pages are scanned, select “2.NO” when the displayshows “ANOTHER PAGE?.”7 The number is dialled then begins transmission when theremote fax machine is ready.NOTE: If you want to cancel the fax, press Stop/Clear at anytime during the transmission.Sending a Fax ManuallyManual sending allows you to talk to the other party beforesending the document. This method is useful if the other partymust manually set their fax machine to receive before they canreceive a fax. For this mode, you need to have a telephoneconnected to the EXT jack on the machine.1 Feed the document(s) face up into the ADF.OrPlace a single document on the document glass face down2 Adjust the document settings if necessary. For details, see“Adjusting Document Settings” on page 2.4.3 Make a call to the remote fax machine from the extensiontelephone connected to your machine.4 When you hear the other party answers the call, starttalking.When you hear the high-pitched fax signal of the otherparty’s fax machine, press Copy/Start.5 Replace the extension telephone.