41Memorizing the ChannelsYour TV can memorize and store all of the available channels for both “off-air” (antenna) and cablechannels. After the available channels are memorized, use the CH and CH buttons to scanthrough the channels. This eliminates the need to change channels by entering the channel digits.There are three steps for memorizing channels: selecting a broadcast source, memorizing thechannels (automatic) and adding and deleting channels (manual).Selecting a broadcast sourceBefore your television can begin memorizing the available channels, you must specify the type of signalsource that is connected to the TV (i.e., an antenna or a cable system).1 Press the MENU button. Press the ▲ or ▼ button to select“Channel”, then press the ENTER button.2 Press the ▲ or ▼ button to select “Auto Program”, thenpress the ENTER button.3 Press the ▲ or ▼ button to select the antenna connection,then press the ENTER button.Notes• Air : “Air” antenna signal.• Cable : “Cable” antenna signal.• Air + Cable : “Air” and “Cable” antenna signals.If the CableCARD is inserted into the “CableCARD”slot on the rear panel, “Cable” and “Air + Cable”are not available.Antenna : Air √Auto Program √Add / Delete √Favorite Channels √Name √Fine Tune √† MoreChannelT VMove Enter ReturnAntenna : Air √Auto Program √Add / Delete √Favorite Channels √Name √Fine Tune √† MoreChannelT VMove Enter ReturnAuto ProgramT VMove Enter ReturnSelect the antennas to memorizeAirCableAir + CableStartStartStartAuto ProgramT VMove Enter ReturnSelect the antennas to memorizeAirCableAir + CableStartStartStart
