18 2A. Device BasicsTurning Your Device On and OffTurning Your Device On Press and hold .Once your device is on, it may display “Searching forService.” When your device finds a signal, it entersstandby mode – the device’s idle state. At this point,you are ready to begin making and receiving calls.If your device is unable to find a signal after 15 minutesof searching, a Power Save feature is automaticallyactivated. When a signal is found, your deviceautomatically returns to standby mode.In Power Save mode, your device searches for a signalperiodically without your intervention. You can alsoinitiate a search for Sprint service by pressing any key(when your device is turned on).Turning Your Device Off1. Press and hold for two seconds until yousee the Phone options menu.2. Tap Power off and then tap OK to power offthe device.Your screen remains blank while your device is off(unless the battery is charging).Status Bar – Messaging IconsText Message – You have new text (SMS) ormultimedia (MMS) messages.Voicemail Message – You have a new voicemailmessages.Voicemail Message – You have multiple newvoicemail messages.New Email message – Shows you have receivedeither a new Internet email message or Outlookemail message via an Exchange server.New Gmail message – Shows you have receiveda new Gmail message.Alarm – You have an alarm event.3Tip: The Power Save feature conserves your battery powerwhen you are in an area where there is no signal.SPH-D700.book Page 18 Tuesday, August 17, 2010 11:14 AM