20HOW TO USE WATER DISPENSER (MODELS APPLIED : SR-608EV/648EV/688EV)122.53 4Please lift up and pull out the water tank.• Please hold the groove of both hand grips andpull out the water tank while lifting it up.• Please clean the inside of water tank when usingit for the first time.(Refer to page 21)Please close the refrigerator doorafter inserting the water tank.• Please confirm whether the waterexit of water supply device is outsideafter closing the door.Please press down the water sup-ply lever with hands after placingcup on platform for cup.Please fill the water tank with water after placing it up on flat surface except for water sup-ply device.• Please supply the water up to 2.5l of water level window since water may overflow when clos-ing the round lid if water is too full.• It is possible to fill the water with water tank inserted in the refrigerator.Groove for hand-gripWater level windowRound lidWater tankWater supply deviceHand-gripMethod 1.: Please fill the water after lift up the round lidto the arrow direction to open it.Method 2.: Please fill the water after holding and liftingboth hand-grips of large lid to open it.• Please lay the cup deep inside to the extent thecup can reach the inner wall slightly.• If hands were removed from cup, there is nowater supplied.• Please desert 2~3 cups of water when using thewater dispenser for thefirst time afterinstallation.• In case of continuouswater drinking, about10~15 cups of waterare availble.Water supply lever